I am sure you remember my post “25 times 2”. I cut out the name “Ronk” and said to watch for a future post and this is the “Ronk” post.
Now cut the letters out contact paper. I used the Cricut cartridge “Cuttin Up.” Take note that the contact paper will have the back or printed side up when you cut since we are putting the image on the bottom of the glass tray.
Place the contact paper on the bottom of the glass tray and don’t forget to put the “middles” in the letters were needed.
The “Armor Etch” was purchased at Hobby Lobby. (of course I used a 40% off coupon) Use caution with this product. Avoid Contact…wear gloves. Put the Armor Etch on very thick with a brush. The instructions I had said to leave it on 5 to 7 minutes. I think I should have left it on a little longer.
Run the tray under hot water to remove the Armor Etch
Finished Present for the Newlyweds…Congratulations Cindy & Dave